相关文章

自行走液压升降机使用注意事项

来源网址:

自行走液压升降机是目前国内最理想的高空作业设备,整体采用高强度铝型材精制而成,具有自动行走功能,那么大家在使用时应该注意哪些问题呢?

Self-propelled lifts operating wind speed should not exceed 20m / s, when used, can not be stopped at an inclination of 30 ° slope greater than work to prevent lift decline.

2、架设和接高时风速应不大于12m/s,打开总开关后,电量显示小于40﹪时,要及时充电。充电时要检查一下电瓶水,若小于20ml,既得加水。

After erection and then high wind speed should not exceed 12m / s, open the master switch, battery indicator is less than 40%, should be promptly charged. To check the battery while charging water, if less than 20ml, vested with water.

Self-propelled lifts normal operating ambient temperature should not exceed 20 ~ 40 ℃, self-propelled lifts operating voltage fluctuations should not exceed ± 5% power grid capacity should be greater than 70KVA.

4、严禁超载运行,单个吊笼不带对重时载重1t,带对重时载重2t,新装的液压升降机必须进行满载坠落试验,以后至少每三个月一次。

Do not overload run, single hoists without counterweight when the load 1t, with a heavy load when 2t, newly installed elevator full drop test must be carried out after at least once every three months.

5、自行走液压升降机导轨架最大自由高度应不大于9m,简易自行走式液压升降机所用的马达,要能承受极频繁的启动、停止和换向作用;能在重载下起动,就是要有较高的起动转矩,以及较小的起动电流。

Maximum freedom to go their own lift rail rack height should not exceed 9m, simple self-propelled lift motor used to be able to withstand extremely frequent starting, stopping and reversing effect; to be started at heavy loads, is to have a higher starting torque, and a small starting current.